Description
*A rail stop is a vertical stopper located on the underside of the Nerf mount and is featured on almost every Nerf blaster. Each rail comes with a relief cut on the underside to allow the rail to slide past the rail stop a given distance.
DETAILS:
Designed for multiple different magazines*.
*NOTE: Make sure the base of the mount (1 ¾ inches) will fit on your blaster.
*If you’re unsure if your magazine will fit, email us at 3dps@3dprintedsolid.com.
*The following magazines have been tested to fit:
Blasterparts banana (15 dart); Buzz Bee (8/20 dart); F10555 “P-Mag” banana (15 dart); Nerf 1st gen glowing (18 dart); Nerf 1st gen (6/18 dart); Nerf older drum (18/25/35 dart) ; Nerf 2nd gen (6/12/18 dart); Nerf 2nd gen drum (25 dart); Rebelle (12 dart); Rebelle glowing (10 dart); Nerf banana (10 dart); Nerf double “flip-clip”(12 dart); Nerf Star Wars (12 dart); Worker banana (15 dart)
COLORS:
– Black
INCLUDED:
– (1) Magazine Clip Holder with Mount
– Hardware
DIMENSIONS:
Single
3.75 in L x 2.12 in W x 1.12 in H | 95.25 mm L x 53.85 mm W x 28.45 mm H
Double
3.75 in L x 3.31 in W x 1.12 in H | 95.25 mm L x 84.07 mm W x 28.45 mm H
TOOLS REQUIRED:
You’ll need a 7/64” hex wrench.
Don’t have an arsenal of tools in your basement? Click HERE to purchase tools!
INSTALLATION:
Slide the Clip Holder mount on to the Nerf rail and tighten screws until snug.
Reviews
There are no reviews yet.